Super Quality Bearing Carry Return Friction Impac | RFQ Sourcing Details

Drive pulley The driving drum is the main component of transmitting power. Dt-ii drive drum according to the load capacity is divided into light, medium and heavy three types, drum diameter of 500, 630, 800, 1000mm. with A roller has several different shaft diameters and center spans for selection.

1) Light: bearing aperture is 80 ~ 100mm, shaft and wheel hub are single key connection, drum is a single plate welded structure, one-way shaft.

2) Medium: bearing aperture is 120 ~ 180mm, shaft and hub are single key connection, there are two kinds of one-way and two-way exit shaft 3) Heavy duty: bearing aperture is 200 ~ 220mm, expansion sleeve connection is cast welding cylinder structure.

The surface of the roller is covered with smooth steel, herringbone and diamond pattern rubber. Herringbone pattern rubber surface friction number, good drainage, but directional, When installing the herringbone tip should be consistent with the conveyor belt running direction.

The conveyor running in both directions should use a diamond pattern. For important occasions, be sure to Coated with vulcanized rubber;For flame-retardant, flameproof occasions should be used corresponding explosion-proof. Bearing seats are all lubricated with oil cup grease.

Bend pulley It is used to change the running direction of the conveyor belt or increase the wrapping Angle of the conveyor belt on the transmission drum, and its structural form is divided into light, medium and heavy Three types, the shaft of the grade diameter of 50 ~ 100mm,120 ~ 180mm and 200 ~ 260mm, the surface of the drum has bare light Steel surface and smooth rubber surface two.

Drive device: by motor, reducer, high speed shaft coupling or hydraulic coupling, brake, low speed shaft coupling and backstop composed of drive single The yuan is fixed on the drive frame, and the drive frame is fixed on the foundation. Detailed Photos Product Parameters Certifications